Hi everyone, I'm experiencing an issue with my Tuya smart door lock and Smart keypad setup, both of which are connected to the internet via a Bluetooth/ZigBee gateway. I've set up an automation on the Smart Life app where entering a correct pin code on the keypad should unlock the door lock...

Hello, the multi-control associations in my home went absolutely mad. Most of them are malfunctioning. I noticed this malfunction today in the morning (CET). Some of them are working only partly, some of them are not working at all, some of them are actually trigerring wrong switches and not...

Like at topic there is some kind solution for it? It's not working property to getting 100 per minute about event (for example humidifier temperature higher as 30°). It's flood message unusable.

I have several Zigbee sensor. I want to use with the tuya smart trigger function in this Alarm Host system, but the alarm is issued with a detection signal even during the delay time at the start of arming, unlike the 433MH's sensor. So, I set the same delay time with the Tuya automation...

I have a door sensor in my bedroom. When i am going to bed i want to turn off all the remaining lights. But i want this with a delay so when my girlfriend is going to do something in the bedroom for a couple of minutes i dont want the lights to turn off in the livingroom. How can i make a delay...

Hi, Thanks for the great app. I have an automation set up to switch on the heater if temp goes below a specific point. I would like to get a push notification when this happens. Is it possible? If not, this would be a great option to have on each automation or condition.