How to connect hardwired sensors to X9 Wi-Fi/GSM alarm panel

[Anonymous]

Have 1 X9 panel and l need to wire 6 external pirs (VS-YH800 )on 2 wired Out puts and am using 2 VS-WSJGH out door sirens l am using a separate 12 v supply for pirs and Siren . my problem is l can not under stand how to connect the tamper and alarm circuits from panel and pir and wiring at the siren thank you and sorry for bad drawing

 

[Admin]

Please watch this video:

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Some tips:

• EOL resistor should be connected either in parallel (Normal Open) or series (Normal Close).
• If using multiple hardwired sensors, separate power supply should be used.
• Do not use COM terminal for sensor connection, it's used for alarm relay output.
• Sensor's GND should connect to - negative of power input on alarm panel.

If need to connect with multiple sensors to a single zone:

Reference sources: hardwired or wireless zones