Hello, i am trying to connect my IP camera to my UL-TECH DVR, when i do a scan it finds my camera but when i put the device password that is located on the bottom of my camera it says "Wrong password" any ideas?
It says "User Name and Password, but my camera only have a device ID and password "123" on the bottom of it".
DVR's Remote Access Configuration
Channel: 5
Time Sync: Enabled
Protocol: ONVIF
Device Type: IPC
Stream: Main Stream
Remote Access: 1
Device Address: "The cameras IP"
Port: 5000
Username: I am using the devices ID on the bottom of the device here as i don't know any other user name?
Password: I am also using the devices password on the bottom of the device "123".
I'm sorry if this is in the wrong section or if this post isn't relevant to this forum.
Thanks in advance.
It says "User Name and Password, but my camera only have a device ID and password "123" on the bottom of it".
DVR's Remote Access Configuration
Channel: 5
Time Sync: Enabled
Protocol: ONVIF
Device Type: IPC
Stream: Main Stream
Remote Access: 1
Device Address: "The cameras IP"
Port: 5000
Username: I am using the devices ID on the bottom of the device here as i don't know any other user name?
Password: I am also using the devices password on the bottom of the device "123".
I'm sorry if this is in the wrong section or if this post isn't relevant to this forum.
Thanks in advance.
Last edited: